We're Movin' on Up

11/ 30/ 2021

Tormach has been in our current building for more than seven years, but sometimes growth and opportunity mean you have to change your surroundings.

Read More...

Thankful Machinists Want These Aftermarket Goodies for the Holidays

11/ 23/ 2021

It’s that time of year once again. And let’s be honest, most of the folks reading this are looking for goodies to buy themselves for the holidays… but we figured it was easier to justify a purchase to your significant other if it was on a list from a trusted resource. Right?

Read More...

8L Lathes Are Performing in the Wild

11/ 16/ 2021

A little less than one year ago, we announced the 8L Lathe would be joining the Tormach family of machines. Now a little less than 12 months later, we are starting to see what the 8L is capable of out in the wild.

Read More...

Tormach ZA6 - Not Your Typical Machine Tending Robot

11/ 09/ 2021

Robotics

The new Tormach ZA6 robot can be used for a number of different applications, so when it entered the beta phase, we weren’t exactly sure what our testers were going to do with it.

Read More...

Set Up QC Reminders on your Tormach

11/ 02/ 2021

Any time you are machining parts that interface with other components (spoiler alert: almost ALL parts!), tolerances can be critically important! Equally as important is checking these tolerances – the more frequently you do so, the less likely you are to scrap – or even worse, send out - bad parts.

Read More...

Section 179 Makes Tormach Machines Even More Affordable

10/ 28/ 2021

If you run a small business - or want to start running a small business - taxes are always an important challenge to consider. You have to know where you can take tax breaks and where they don’t fit your organization.

Read More...
1 of 94